Safety operating procedures for sheet metal fiber laser cutting machines
- Follow the general safety operating procedures for sheet metal fiber laser cutting machines. Strictly follow the laser startup program to start the laser.
- Operators must undergo training, be familiar with equipment structure and performance, and master knowledge related to operating systems.
- Wear labor protection equipment according to regulations, and wear protective goggles that comply with regulations near the laser beam.
- Before determining whether a material can be irradiated or heated with laser, do not process it to avoid potential hazards such as smoke and vapor.
- When the equipment is in operation, operators are not allowed to leave their posts or entrust someone to be in charge without authorization. If it is necessary to leave, the machine should be shut down or the power switch should be cut off.
- Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth, or other flammable materials near unprotected laser beams.
- If any abnormalities are found during the processing, the machine should be stopped immediately, and the fault should be promptly eliminated or reported to the supervisor.
- Keep the laser, bed, and surrounding area clean, orderly, and free of oil stains, and stack workpieces, boards, and waste materials according to regulations.
When using gas cylinders, it is important to avoid damaging welding wires to prevent electric leakage accidents. The use and transportation of gas cylinders should comply with the gas cylinder supervision regulations. Do not expose gas cylinders to direct sunlight or close to heat sources. When opening the bottle valve, the operator must stand on the side of the bottle nozzle.
- During maintenance, high voltage safety regulations must be followed. Follow the regulations and procedures for maintenance every 40 hours of operation or every week, every 1000 hours of operation or every six months.sheet metal fiber laser cutting machines
- After starting up, the machine should be manually started at low speed in the X and Y directions to check and confirm if there are any abnormal situations.
After inputting the new workpiece program, a trial run should be conducted and its operation should be checked. sheet metal fiber laser cutting machines
- When working, pay attention to observing the operation of the machine tool to avoid accidents caused by the laser cutting machine leaving the effective travel range or collision between two machines.sheet metal fiber laser cutting machines
A laser cutting machine costs tens of thousands or even hundreds of thousands of pieces of equipment, so attention must be paid during operation, and regular maintenance and upkeep are necessary to increase the service life of the equipment, save costs, and create greater benefits.
